A sump pump collects and eliminates water that accumulates beneath a basement floor. In other words, a sump pump prevents water from flooding your basement. A sump pump check valve improves the efficiency and prolongs the life of a sump pump.
In this blog post, we will discuss sump pump check valves and the benefits of installing one. We will also look at some connection types.
A sump pump check valve is a one-way, flapper style valve. It should be installed in the discharge pipe of the sump pump. When the pump starts, the force of the water opens the flapper and water is forced out through the valve. When the pump stops, the valve flapper closes, stopping the back-flow of water. A sump pump check valve ensures that water that has been pumped out does not come back into the pit.
Valves with a flat seat will make a clunking noise when the flapper fully closes. When the valve hits the seat, this impact is called water hammer. Choosing a valve with an angled seat will reduce the effects of water hammer and choosing a valve with a spring-loaded flapper will reduce it even more.
There are a few reasons why you should install a sump pump check valve.
Without a check valve, gravity will push the water in the discharge pipe back down into the pit. A check valve stops water from being pushed back down, and in turn, prevents the pump from having to re-pump water out. Having to re-pump water could result in short cycling.
Short cycling can happen when a check valve is installed incorrectly. If the check valve is installed incorrectly, such as high up on the discharge pipe, the water below the check valve will drain back into the basin and cause the water level to quickly rise. With this rising water, the pump will have to start again and over time, your pump will wear out from having to re-pump the same water out. Eliminating short cycling is better for the environment and saves on electricity costs.
Short cycling causes the pump motor to run at a higher temperature. Heat is terrible for electric motors because it can drastically shorten the life of a pump. By installing a check valve, the risk of short cycling is reduced, and in turn, extends the life of the sump pump.
There are five different connection types for connecting your check valve to the pump.
Barbed, also known as inserts, are inserted into tubing and stay snug because of their design. Barbs can be large, small, or more spaced out depending on the fitting and what it is intended to be used for. If you’ve used or plan to use a corrugated drain hose, then use a barbed check valve. Be sure to use a hose clamp in conjunction with the barbed connection.
Flexible rubber coupling, also known as rubber boot, fits over a pipe and is attached by tightening the clamp. Instead of having to buy a slip/spigot check valve and a rubber coupling separately, a flexible rubber coupling offers these two items together.
A sump pump check valve should be installed close to floor level to minimize the volume of water that drains back at the end of each pumping cycle. This location also allows for easy servicing of the valve.
In summary, without a sump pump check valve, your system has to work much harder to pump out the same amount. Installing a sump pump check valve helps to reduce the stress put on your sump pump, and thus, saves on energy costs and prolongs the life of the pump by limiting the amount that the pump has to run.
For more on sump pumps, check out our blog post on 5 must-have Plumbeeze products for every homeowner.